NEW! ODIN WORKS CQ UNBRACED Stock Conversion Kit

Required Tools and Hardware

• 9/64″ hex wrench (supplied)
• (2) 8-32 x 1/4″ socket head cap screws (supplied)
• (2) existing 8-32 x 1/2″ socket head cap screws (retained from CQ-B assembly)
• Threadlocker (optional)

Installation Procedure
Step 1 – Prepare the Assembly

Begin with your complete ODIN Works CQ-B (Close Quarters Brace) assembly. Confirm the firearm is unloaded and safe before beginning installation, and follow the manufacturer’s firearm-handling instructions.

Step 2 – Attach the CQ-S Plate to the Adapter Mount

Using a 9/64″ hex wrench, attach the CQ-S plate to the adapter mount with the two supplied 8-32 x 1/4″ socket head cap screws.

• Locate the two threaded cross holes at the top of the adapter mount.
• Position the V-shaped plate with its widest portion at the top.
• Start both screws, but do not fully tighten them at this time.

Step 3 – Remove the Existing Brace Armrest

Remove the two existing 8-32 x 1/2″ socket head cap screws securing the pistol brace armrest (the fin-shaped component used to attach a Velcro® strap).

Retain both screws for installation of the adapter mount and plate assembly.

Step 4 – Install the Adapter Mount and Plate Assembly

Position the adapter mount and plate assembly in place, with the CQ-S plate facing toward the rear of the stock.

Reinstall the two retained 8-32 x 1/2″ socket head cap screws, inserting one from each side. Tighten both screws until snug.

Step 5 – Align the CQ-S Plate

Viewed from the rear of the stock, adjust the plate so that its contour aligns with the surrounding cheek rest around the buffer tube.

Check the alignment visually before proceeding.

Step 6 – Secure the CQ-S Plate

Once the plate is properly aligned, tighten the two 8-32 x 1/4″ socket head cap screws until snug.

Step 7 – Final Inspection

Verify that all four screws are secure and that the CQ-S plate is properly aligned with the cheek rest.

If the screws tend to loosen during operation, apply a suitable threadlocker according to the threadlocker manufacturer’s instructions.

Installation is complete.